Finish

Export harden

Built for kit runs, our export harden finish is engineered for garments that need to travel further and push through more wear and tear.

Export harden

Export harden turns your DTF transfers into workhorses, delivering a firmer, more resilient print that stays put from shipping box to field and back again. Designed for bulk orders, kit bags and anything facing long hauls or hard play, this finish holds its own in the wash and on the road.

What export harden looks and feels like

This finish has a purposeful feel: firmer than a soft-hand fashion transfer, with a satin-matte look and a bit more bite in the hand. On cotton and polycotton, you’ll notice the print feels slightly raised, with edges that stay crisp even after repeated handling and folding. Colours are bold and fully opaque, with a white underbase that locks in place to block show-through.

Export harden suits school and sports kits, workwear, event gear, and any order that needs to look sharp after bulk washing, packing, and transit. The finish is built for resilience, which makes it ideal where prints face rubbing, stacking, or rough-use cycles.

How to build the export harden finish

To get this result, start with a double-matte cold peel film for maximum stability and detail hold. Use a coarser or workwear-grade TPU powder: it forms a tougher bond and gives the transfer a firmer edge on heavier or textured fabrics. Apply powder generously, shake off the excess and cure until the adhesive turns glossy with a fine orange-peel texture, usually 3 minutes at around 120 degrees C in an oven.

Press onto the garment at medium-firm pressure: 150 to 165 degrees C for 10 to 15 seconds on cotton, 130 to 140 degrees C for 12 to 15 seconds on polyester. Always cold peel for this finish, let the print cool fully before peeling low and slow. For extra durability, finish with a 10-second press through a Teflon sheet.

  • Double-matte cold peel film
  • Coarse or workwear TPU powder
  • Cure until glossy orange-peel texture forms
  • Cold peel, then finishing press

What to check after washing and wear

After the first wash, check that edges stay flat and the print sits tight with no lifting or cracking, especially on seams and collar points where friction is highest. Expect the transfer to soften slightly but keep its defined edge and opacity.

Exports and kits often face long storage, so inspect for any powder residue or stiffness after shipping. If a batch feels too stiff, try reducing press time by 2 seconds or switching to a slightly finer powder on the next run for better balance between toughness and flex.

Customer reviews

What our DTF Ink customers say

Verified Google reviews

Talk to DTF Ink

Tell us about your printer, film, powder and press settings and our team will help you get repeatable transfers. Meadowdale lab in Germiston, plus seven studios.