Recipe
Polyester press temperatures
Press DTF on polyester kits at 125 to 140 degrees C with a cold peel to avoid scorch marks, shine and dye migration ghosting on the print.

Most new DTF decorators start off with cotton, but as soon as school kits, sportswear or corporate uniforms come in, polyester brings its own set of challenges. The right press temperature is crucial: too hot and you risk shiny marks, dye migration, or even ghosting. I’ll share the press-side tweaks we use at DTF Ink to get clean results on polyester, from cheap kit tops to moisture-wicking performance gear.
Why polyester needs a different approach
Polyester fabrics are heat sensitive. Unlike cotton, poly shifts, scorches, or goes shiny if you press too hot or for too long. On top of that, poly garments, especially brights and reds, often have loose dye that migrates upwards into the DTF print if the press is too hot or for too long. This is most obvious as pink or yellow haze in the white underbase after a few washes, but with some shirts it can show up as soon as it cools.
Many decorators assume the same 150 to 165 degrees C they use for cotton will work for everything, but you need to drop your settings for poly. Polyester also holds moisture longer, especially in our coastal regions. Always pre-press to clear out humidity trapped in the fibres, or you’ll see steam blisters under your transfer.
Starting points for press settings
For standard polyester shirts, I start at 125 to 140 degrees C, pressing for 10 to 15 seconds at medium-firm pressure. Always check the film you are using: some cold-peel films need a slightly longer press time at the lower end of the temperature range, while hot-peel films might not release smoothly unless you’re closer to 140 degrees C.
Pre-press the shirt for 2 to 5 seconds to drive off any moisture. This is essential on misty Highveld mornings or humid coastal days. Use an infrared thermometer to check your platen temperature, especially at the corners, as cold spots can leave areas under-cured and lead to poor adhesive bonding or even prints lifting in the wash.
Avoiding scorch marks, shine and ghosting
Satin shine and press marks are a common headache on poly kit and team shirts. Always use a quality Teflon sheet or siliconised parchment over the transfer to spread out the press weight and shield the fabric. Never press longer than needed, over-pressing is a major cause of shiny rectangles on poly blends.
Ghosting, where you see a light shadow around the print after peeling, comes from movement between the fabric and the film when the press opens. For cold-peel applications, let the transfer cool completely before peeling. For hot-peel films, use a smooth, confident motion to avoid shifting the shirt. If you see marks, try lowering the pressure a notch and double-check that your press is opening vertically, not dragging as it lifts.
Quick checks and common mistakes to avoid
South African print rooms see a few classic errors on poly, especially when moving fast in school season or during a big sports kit run. Here’s my checklist for a clean polyester press:
- Don’t skip the pre-press, always flatten and dry the shirt first.
- Use the lowest temperature and shortest press time that gives a solid bond.
- Always check your white ink and nozzle pattern before starting a run, weak white shows up fast on dark reds and navies.
- Store your films sealed and flat, away from the print oven and sun.
- Run a wash test on a sample shirt before the full job, especially with new film or powder.
Talk to DTF Ink
Tell us about your printer, film, powder and press settings and our team will help you get repeatable transfers. Meadowdale lab in Germiston, plus seven studios.


