Recipe
White underbase on dark tees
Getting solid, crisp white that holds up on dark shirts means tuning opacity, controlling choke and knowing how to keep your white ink healthy.

As a colour and RIP specialist working with DTF every day, I’ve seen that the white underbase is the backbone of any print on a dark shirt. If your white isn’t right, your colours will look dull and designs can wash out fast. Here’s how I approach white underbase for South African print rooms, from ink handling to press checks.
Keep your white ink alive and moving
White pigment is heavy, and if it settles in the bottle or lines your prints will suffer. I always shake fresh white bottles before topping up tanks, and at the Meadowdale lab we run the printer’s white circulation cycle before every shift. Don’t skip the daily nozzle check, if you see broken or missing lines, stop and clean before you waste film. A weak or patchy underbase nearly always comes down to settled ink or clogged nozzles. On busy days, agitate open white bottles every couple of hours, especially in winter on the Highveld when the air is dry and static can make things worse.
Get the opacity you need without flooding the garment
A solid white layer is critical for bold colours but too much ink causes bleeding or a stiff feel. In most RIPS, I set the white underbase to 80 to 90 percent opacity as a starting point for cotton. On heavy black garments or when the base fabric is textured, go up in small steps but watch for ink pooling or slow drying on the film. If you’re running a large job, print a small white block on scrap and press it to check coverage before committing to the whole run. The best DTF whites strike a balance: enough pigment for opacity, thin enough to stay soft after pressing. If you’re running a film batch with a new roll or in coastal humidity, be ready to make slight tweaks.
Choke the underbase to avoid white halos
If you’ve ever seen a pale border around a bold print, that’s the white underbase peeking out where the colour layer shrank or misaligned. To solve this, use your RIP’s choke control: I usually start with a 0.2 to 0.35 mm choke on standard tees. For very fine detail like script or outlines, go a bit tighter but test, because too much choke will make thin colours patchy. If you forget to choke, you’ll spot it in the first few peels. It’s one of the most common issues new DTF print bays bring us. Always check the first prints up close before you start a big production run.
- Set choke in the RIP settings
- Start with 0.2 to 0.35 mm for most tees
- Check detail prints for colour break-up
- Adjust choke for new film or fabric types
When to reach for an extra white bottle
Some jobs just eat white ink: club kits, heavy cotton hoodies, or large solid logos on deep navy. If you’re running full coverage on dark tees, be prepared to go through white bottles faster than CMYK. It’s tempting to try stretch the last bit, but don’t risk running a tank low mid-job, underbase starvation leads to banding or a ghosting effect that’s hard to fix. I always keep an extra bottle or two at hand, especially during school term rushes and festive season orders. If you ever spill powder or ink, clean up straight away before it clogs the capping station or seeps under the platen.
Talk to DTF Ink
Tell us about your printer, film, powder and press settings and our team will help you get repeatable transfers. Meadowdale lab in Germiston, plus seven studios.


