Finish
Satin club
Satin club is a DTF transfer finish with a gentle, subtle gloss that stands out crisply on badges and school kit crests.

This finish gives your prints a smooth touch and slight shine without looking overly glossy. It shows club colours and sharp logos to good effect, especially on darker PE tops, supporter jackets and kit bags.
How satin club transfers look and where they fit best
Satin club transfers have a soft, almost velvet-sheen surface that reflects light just enough to highlight the print’s colours and border details. The print sits low on the garment and flexes with movement, giving a crisp outline that doesn’t scream plastic. On kit crests, sports badges and school teamwear, this look reads professional and smart, eye-catching for matches and assemblies but subtle enough for year-round wear.
It works well on cotton and polyester, especially where you want club identity front and centre. Satin club is a popular pick for PE tops, rugby jerseys, tracksuits, kitbags and supporter gear, anywhere a neat crest or sharp logo is the hero of the piece.
Steps for achieving the satin club finish
Getting a satin club finish is mainly about your film, powder and press technique. Use a double-matte PET film made for hot peel, as this lays down a slightly glossy surface without heavy shine. For powder, pick a fine or soft-hand TPU adhesive for smoothness and detail. Cure the powdered print at 110 to 120 degrees C for 2 to 3 minutes in an oven or float under your press at 140 degrees C with a 5 mm gap for 3 to 4 minutes until you see a fine, even orange-peel gloss.
Press the transfer at 155 to 160 degrees C for 12 to 15 seconds at medium-firm pressure. Peel hot in one steady movement a few seconds after opening the press. To enhance the satin look and feel, finish with a light 5-second press through a Teflon sheet.
- Use double-matte hot peel PET film
- Fine soft-hand TPU powder for a glassy surface
- Cure until powder just turns glossy (not yellowed)
- Press 155 to 160 degrees C, 12 to 15 seconds, medium-firm
- Peel hot, then short Teflon finishing press
What to check after washing and wear
After regular washing and wear, satin club transfers should hold their slight sheen and smooth feel if properly cured and pressed. Check that no edges have lifted and that the print hasn’t dulled or cracked. Excessive pressing or over-cure can stiffen the print or create a high gloss that looks off-spec.
If the surface loses its satin look or picks up scuff marks, revisit your powder cure time and press temperature. It’s always worth washing a test garment inside out at the recommended cycle before running a full batch for clubs or schools.
Keep reading
Customer reviews
What our DTF Ink customers say
Verified Google reviews
Talk to DTF Ink
Tell us about your printer, film, powder and press settings and our team will help you get repeatable transfers. Meadowdale lab in Germiston, plus seven studios.

