Pressed sample

Club crest close

A detailed close-up of a pressed DTF crest for a local club, applied to a midweight polyester-blend kit top using DTF Ink’s hot-peel system.

Club crest close

The club crest shows crisp borders and clear colour detail, even across seams and slight texture. This sample demonstrates how DTF transfers can handle small lettering and intricate shapes on technical kit fabric.

Club crest and garment details

This sample features a club crest printed and pressed onto a midweight polyester-blend kit top, typical of school and sportswear uniforms. The crest includes fine outlines, layered colours and delicate inner details, pressed over a slightly textured surface. The transfer sits flat with no visible lifting at the edges, a key need for kit expected to survive training and repeated washing.

A hot-peel film was used, matched to the fabric’s smooth finish, allowing the transfer to be peeled within seconds of pressing. This technique suits team kit production, where speed and repeatability matter, especially for multi-size runs or when pressing onto seams and panels.

How this transfer was made

The crest was printed using DTF Ink’s CMYK plus white DTF ink set, with daily agitation of the white bottle to keep pigment suspended. The PET film was a double-matte hot-peel type, stored flat and sealed until use. Powdering was done with the fine soft-hand TPU adhesive for a smooth finish and to hold the crest’s small details.

Powder was cured for 3 minutes at about 120 degrees C in a curing oven, until the surface showed a glossy, light orange-peel texture. The kit top was pre-pressed for 3 seconds to flatten and dry the area, then the transfer was applied at 150 degrees C for 12 seconds at medium-firm pressure. Peeling was done hot, within 5 seconds, in a single smooth pull.

  • Daily white ink agitation
  • Fine-grade TPU powder for detail
  • Double-matte hot-peel film
  • Press at 150 degrees C for 12 seconds

How to repeat this result for your kits

To achieve crisp crests like this, keep your white DTF ink well-mixed and run a nozzle check before each production run. Use fine adhesive powder for best detail on logos and text. Always store film dry and dust-free to prevent static and smudging.

Pre-press polyester kit tops to remove moisture, and test your heat press for cold spots using an infrared thermometer. Start with the press settings above, but always run a test press and peel to check for dull or weak white, which usually means nozzle or ink issues. If the edges ever lift after washing, check your press pressure or finish with a 7-second post-press through a Teflon sheet.

  • Mix white ink and nozzle check daily
  • Fine powder holds detail on crests
  • Pre-press to flatten kit fabric
  • Test press pressure and peel speed

Customer reviews

What our DTF Ink customers say

Verified Google reviews

Talk to DTF Ink

Tell us about your printer, film, powder and press settings and our team will help you get repeatable transfers. Meadowdale lab in Germiston, plus seven studios.