Pressed sample

Dark underbase

A navy cotton tee showing a dense white DTF underbase for crisp colour stand-out.

Dark underbase

This sample demonstrates a strong opaque white layer pressed onto navy combed cotton before the CMYK colours are applied. Dark fabrics like navy need a solid white underbase to stop the garment colour from muting the print.

What the sample shows on dark cotton

Here you see a navy blue T-shirt decorated with a vibrant multi-colour print using DTF. The print pops cleanly off the fabric because the white underbase does its job: it fully blocks the dark garment so the colours on top stay true, especially the lighter shades and skin tones.

This sort of result is most useful for sports and club kit, staff uniforms, or any fashion item where you want the artwork to stay sharp and visible on deep or saturated base fabrics.

  • Navy combed cotton T-shirt
  • DTF white underbase plus CMYK top colours
  • Pressed at 160 degrees C for 15 seconds, hot peel

How we made this test transfer

The artwork was printed in mirror onto double-matte PET roll film, with a thick white channel set as the base. We agitated the white ink bottle, ran a nozzle check and a quick white circulation before starting. For the powder, we used a fine soft-hand TPU and cured at 120 degrees C for about 2 and a half minutes in our oven, checking for the right orange-peel gloss.

The T-shirt was lint-rolled, then pre-pressed for 3 seconds to remove moisture. After positioning the cured transfer, we pressed it at 160 degrees C for 15 seconds at medium-firm pressure, peeled hot after a few seconds, then finished with a 7 second Teflon sheet press to improve wash and handle.

  • Use double-matte PET film, hot peel
  • Agitate white ink before printing
  • Fine TPU powder for a soft finish
  • Pre-press garment to flatten fibres

How to get the same opaque white at your press

Strong white relies on good ink agitation, a clean nozzle check, and the right underbase settings in your RIP. If your white prints are patchy or greyed out, check the ink bottle for settling, and run the printer’s white circulation and a cleaning before jobs on dark fabrics.

Store transfer film and powder properly: keep them dry and sealed to prevent static or clumping, especially in Highveld winters or humid coastal air. Cure the powder just long enough for a glossy, slightly textured finish, undercured powder will wash away, while overcured powder may yellow or stiffen. Always test your press temperature with an infrared thermometer and adjust times for your own batch and equipment.

  • Daily agitation for white ink
  • Check humidity to prevent static or clumping
  • Adjust press temp for your garment type
  • Inspect for even white before adding colour

Customer reviews

What our DTF Ink customers say

Verified Google reviews

Talk to DTF Ink

Tell us about your printer, film, powder and press settings and our team will help you get repeatable transfers. Meadowdale lab in Germiston, plus seven studios.