Pressed sample
Poly panel
Polyester sports panels can take a sharp, clean DTF transfer if you get the basics right.

This sample shows a white DTF transfer on a lightweight polyester panel, as used for team kits and training tops. The edges are crisp, with no bleed or dye migration, and the fabric surface remains smooth.
This sample shows a clean result on sports polyester
You’re looking at a pressed polyester panel cut from a standard sports vest. The print uses DTF Ink’s CMYK plus white DTF ink and a hot-peel PET film on a lightweight, tightly woven polyester typical of club and school kit. The panel was pre-pressed to flatten the fibres and drive out humidity, then transferred with a white underbase and colours on top. The end result: no visible bleed or colour shift, and the stretch of the fabric is unaffected.
Polyester can be tricky for DTF if the settings are off, but here the transfer sits on the surface with no puckering and the feel stays soft.
How we pressed this poly panel sample
We printed onto a cold-peel PET film with fine TPU powder, then cured for about 3 minutes at 110 degrees C in a tunnel oven. After letting the panel and film cool for at least a minute, we peeled the film low and slow to avoid lifting any detail.
The press was set to 135 degrees C for 12 seconds at medium-firm pressure, working as a safe starting point for most poly sports kits. A final 7-second finishing press through a Teflon sheet improved the durability and gave a softer touch.
- Cold-peel film, fine powder, full cure
- Allow film and panel to cool before peeling
- Medium-firm press, lower temperature than cotton
How to get this result on your own polyester garments
Pre-press each garment for 2 to 5 seconds to drive out moisture and flatten seams. Choose a cold-peel PET film and fine TPU powder for smooth results with less risk of dye migration. Always test your press for cool and hot spots with an infrared thermometer before a big run.
If you see colour bleeding or the panel scorches, try lowering the temperature to 125 degrees C and extend the press to 15 seconds. Check the white ink layer for even coverage and always run a nozzle check before starting, as patchy white is a common cause of weak colour on synthetics.
- Pre-press to remove moisture
- Cold-peel film and fine powder recommended
- Check white ink flow before big jobs
- Test for scorching or bleed on your blanks
Keep reading
Customer reviews
What our DTF Ink customers say
Verified Google reviews
Talk to DTF Ink
Tell us about your printer, film, powder and press settings and our team will help you get repeatable transfers. Meadowdale lab in Germiston, plus seven studios.

