Pressed sample
Powder tray
This DTF Ink sample shows a DTF transfer produced using our soft-hand grade TPU powder in an open powder tray, pressed onto a cotton blend T-shirt.

An open powder tray technique with the fine soft-hand powder gives this print a smooth, flexible feel. The transfer was pressed onto a midweight cotton blend at standard cotton settings.
What this sample demonstrates on a cotton blend
This sample highlights how a fine soft-hand TPU powder can deliver a flexible, low-profile print when applied with an open powder tray. The garment is a 160 gsm cotton/polyester blend T-shirt in light grey, ideal for everyday wear or promo use. The print covers about an A4 area and shows solid, bright colour with a sharp edge and no visible powder residue.
Using soft-hand powder in an open tray is especially effective for detailed logos and artwork where the feel of the finished print matters. You get a finish that sits flat on the fabric, moves well, and avoids the rubbery effect you sometimes find with heavier adhesive grades.
How we made this DTF transfer in the Meadowdale lab
We printed onto double-matte hot-peel PET film using DTF Ink CMYK plus white DTF ink, making sure to agitate the white bottle and run a nozzle test before starting. The fine soft-hand grade powder was sprinkled from an open tray with gloves and a mask, then excess powder was tapped off clean.
Curing was done in a small DTF oven at 110 degrees C for 2.5 minutes. The powder melted evenly and developed a semi-glossy orange-peel surface. The transfer was heat pressed onto the T-shirt at 160 degrees C for 12 seconds at medium-firm pressure, peeled hot five seconds after opening the press, and finished with a Teflon sheet for 8 seconds.
Print room was kept at 50 percent humidity and 22 degrees C to help the powder flow and prevent static.
- Double-matte hot-peel film, A4 sheets
- Soft-hand TPU powder, open tray
- Cure: 110 degrees C, 2.5 minutes
- Press: 160 degrees C, 12 seconds, hot peel
How to get a similar soft feel on your own prints
Store your soft-hand powder sealed, dry, and away from moisture. When powdering by hand, wear gloves and shake off all excess so the print stays flexible after pressing. If you see dull spots or patchy transfer, check that your oven or heat press is reaching the set temperature and that your white ink is freshly agitated.
Always pre-press the garment for 3 seconds to flatten seams and drive out humidity. After pressing, peel hot within five seconds, then add a short finishing press for the best result. If your print feels stiff, try using even less powder or reducing curing time slightly.
Keep your print room at moderate humidity to avoid powder clumping or static. If you get a patchy result, run a nozzle check and increase agitation of your white ink before starting the next batch.
Keep reading
Customer reviews
What our DTF Ink customers say
Verified Google reviews
Talk to DTF Ink
Tell us about your printer, film, powder and press settings and our team will help you get repeatable transfers. Meadowdale lab in Germiston, plus seven studios.

