Recipe
Club crest colour match
Keeping crest reds consistent across a season.

Matching club crests for schools, sports teams and supporters’ kits is a staple for print shops, but keeping those reds on point throughout the season can be tricky. I’ve seen far too many runs where the first batch looked spot on, but the follow-up orders didn’t quite match up. In this recipe, I’ll walk you through my process for keeping reds reliable, from artwork prep to the final press.
Start with accurate artwork and colour targets
The first make-or-break step is getting the right reference for the crest red. Always ask your client for a physical garment or an existing badge as well as the digital file, because screen reds never match garment reds. Use a Pantone swatch book or a printed colour chart on your actual DTF setup to eyeball the closest ink value.
Once you’ve locked your colour target, set up your art files in CMYK, not RGB. Flatten all effects and avoid transparency tricks. If you use RIP software, load your base ICC profile and soft-proof the red area to check for out-of-gamut warnings. Save the file version and colour values for later batch runs.
Control your ink and white underbase
DTF reds need a solid white underbase or they’ll look dull, especially on dark kit. Agitate the white ink bottle every day, and always run a nozzle check before production, settled pigment or a blocked head are the main reasons crest reds come out pinkish or patchy. If you see broken lines on the nozzle check, pause and run a cleaning cycle.
White density can shift in long runs or after a power cut, so keep an eye on the first few prints after any stop or restart. For deep club reds, I often bump the white underbase up slightly in the RIP settings, but don’t overdo it or you’ll get a thick, stiff feel.
Film, powder and press settings for reliable results
Store your PET transfer film sealed and away from dust, static and humidity swings in Joburg winters can leave spots or fuzzy edges on fine crest detail. Use the same film type (hot-peel or cold-peel) throughout a job or season, as switching films changes the look and hand of the print.
For powder, the soft-hand fine grade gives smooth crests. Cure between 100 and 120 degrees C for 2 to 3 minutes in the oven, watching for an even glossy finish. Under-cured powder leaves the red looking milky; over-cured can yellow light reds or edges.
When pressing, pre-press the garment to drive out moisture, especially after a run of rainy days. For cotton, use 150 to 165 degrees C for 10 to 15 seconds at medium-firm pressure as a starting point. Always finish with a 5 to 10 second cover through a Teflon sheet for durability and a better feel.
- Keep film sealed and flat between runs
- Stick to one film type per job
- Watch for static and dust
- Check the press platen with an infrared thermometer
Batch testing and tracking through the season
Before a full run, print a test crest and press it onto the same fabric as the final kit. Compare the test print to your target sample in natural light. If the red looks dull or brickish, double-check your underbase, powder cure and RIP profile.
For big clubs or schools with repeat orders, keep a labelled reference print from each batch in a sample folder. Note the press settings, film and powder batch, and humidity readings if you can. This makes it much easier to match colours for repeat orders after a gap or a seasonal change in weather.
Always wash-test a finished print inside out, using the temperature on the garment label. Edge lifting or colour shift after washing usually means under-cured powder or a weak underbase.
Related
Talk to DTF Ink
Tell us about your printer, film, powder and press settings and our team will help you get repeatable transfers. Meadowdale lab in Germiston, plus seven studios.


