Recipe

Film storage on racks

Store DTF film flat or hung on racks away from damp walls and direct sun, because curled or humid film spoils prints and wastes roll stock.

Film storage on racks

I’m Kevashan Ramsamy, DTF Ink’s main man for everything film and powder. In our Meadowdale lab and at dozens of customer bays, I see the same avoidable film issues again and again, curled edges, dust specks and mystery marks. Storing your PET film properly, whether rolls or sheets, sets you up for crisp, trouble-free transfers.

Why proper film storage pays off

PET transfer film is specially coated for DTF, which makes it sensitive to how and where you store it. If your film is exposed to dust, heat, direct sun or moisture, the coating can pick up static or even degrade. Curled edges, surface specks and static build-up are the three main problems I get called out for, and all of them waste money.

Even small amounts of dust or lint on the film become permanent flaws in your prints after powdering and pressing. If you see jagged white lines or craters in the finished transfer, you’re likely dealing with contaminated film. Edges that curl up or down make sheets run out of register, and they’re a nightmare for feeding into most DTF printers.

How to rack and stack rolls and sheets

The best way to store film rolls is upright on a purpose-built rack, with the original plastic sleeve kept on and the open end facing a wall or away from walkways. Make sure the rods or pegs are wide enough that the roll doesn’t dent or flatten, it only takes a small kink to cause banding.

A3 and A4 film sheets should be kept flat in their factory packs or in clean trays, stacked no higher than about 10 to 15 cm to prevent pressure dents. Never lean sheets upright or wedge them between shelves, or you’ll get curling and dust settling on the edges. I see too many stacks left open on crowded benches, always reseal the bag and lid after every use.

South African print room realities

Our Highveld winters are brutally dry, and aircons or heaters in a bay drop the humidity even further. In these conditions, film gets static-loaded and actually attracts airborne lint and powder particles, which then bake into your transfer. Coastal bays can have the opposite problem, with sticky humidity making some films cockle or matt coatings go soft.

Use a cheap hygrometer to keep a handle on your print room climate. If you’re running fans or aircons, make sure they aren’t blowing straight onto your film storage racks. In older industrial buildings, check for leaking roofs or windows, film soaks up moisture through the open ends of rolls and the sides of open packs. Wet film does not print right and the powder won’t stick evenly.

Checking and handling film for every shift

Before every run, check that your film is clean and flat, don’t just rely on what the pack looks like. Wipe sheets or the exposed outer layer of a roll with a lint-free wipe if you see any specs, fibres or shiny patches. Gently flip through a pack to spot curl or ripples before loading.

When opening a new roll, cut just enough shrink wrap to free one end, then reseal with tape after use. Don’t leave rolls open overnight. Always store partial packs and open rolls in a cupboard or a closed shelf if possible.

All your storage habits add up. If you’re fighting curled film, start with the rack and the pack, then look at the weather.

  • Keep film sealed until needed
  • Store rolls upright and sheets flat
  • Site racks clear of windows and aircon vents
  • Check humidity is between 45 and 60 percent
  • Clean hands and gloves before handling film
Mr Kevashan Ramsamy
Mr Kevashan Ramsamy

Powder and film specialist at DTF Ink. Kevashan knows his way around DTF powders, film peels and the quirks of coastal print rooms.

Talk to DTF Ink

Tell us about your printer, film, powder and press settings and our team will help you get repeatable transfers. Meadowdale lab in Germiston, plus seven studios.