Recipe

High-vis neighbour panels

DTF transfer technique for garment crests alongside reflective tape on safety and workwear.

High-vis neighbour panels

DTF crests and badges often land right next to reflective tape on high-vis workwear, especially on jackets, vests and bibs. I’ve worked with plenty of decorators who have battled scorch marks, peeling at the tape edge or sticky adhesives that leach onto reflectives. Here’s how I set up for crisp, long-lasting DTF prints on these tricky neighbour panels, using our own ink, film and powder.

Plan your panels and artwork to keep clear of tape edges

Start by checking the garment layout. Most reflective tape on high-vis pieces is heat-sensitive and can lift, crinkle or go cloudy if pressed too hot or for too long. I always measure the gap between the edge of the tape and where the DTF crest will sit, leaving at least 5 to 8 millimetres of fabric buffer from the tape edge. This keeps the press heat away from the edge adhesive on the reflectives and stops glue from squeezing out and making a mess.

If the artwork can’t move away from the tape, I trim the transfer film so there’s no carrier film overlapping onto the tape. Never let the PET film sit over reflective tape when pressing, it’s a sure way to cause edge marks or damage the tape’s surface.

Dial in lower press temperatures for poly blends and reflective tape

Most high-vis gear is polyester or a blend, which needs less heat than cotton. I start at 130 to 140 degrees C, pressing for 10 to 12 seconds at medium pressure. Use a cold peel film, it’s safer for both the reflective tape and the fabric, and gives you time to let the panel cool before peeling.

Check your press platen temperature with an infrared thermometer, especially on bigger jobs. Hot spots can burn or warp tape, while cool spots might under-cure the print. If you see any fogging or distortion on the tape after pressing, lower the temperature or drop the time by a few seconds.

  • 130 to 140 degrees C for 10 to 12 seconds (cold peel)
  • Medium, even pressure
  • Pre-press fabric only, not over tape, for 2 to 5 seconds
  • Finish with 5 seconds through a Teflon sheet

Use fine powder and agitate white ink for crisp edges

For best results on workwear panels, I recommend our fine soft-hand TPU powder. It holds the detail needed for small crests and won’t leave a crunchy edge against the reflective tape. Always shake off excess powder before curing, any loose powder left near the tape edge will melt and bond where you don’t want it.

White ink must be fully agitated before every print run, especially for badges where a strong underbase is needed to stop dye migration from the garment. Weak or uneven white prints bleed quickly on poly blends, so I run a nozzle check and a short white circulation cycle after any power cut or long pause.

Peel cool and check the tape edge for clean release

Let the print cool fully before peeling off the carrier film. Rushing the peel can pull at the tape or stretch the fabric, leaving a raised ridge or even a tear along the tape edge. Peel low and slow, using one steady motion across the crest, keeping an eye on the tape boundary.

After peeling, run a thumb along the crest edge and the tape, look for lifting, sticky spots or shiny adhesive bleed. If you spot any, add a short finishing press through a Teflon sheet for 5 seconds to seal down the edges and smooth out the surface.

Mr Kevashan Ramsamy
Mr Kevashan Ramsamy

Powder and film specialist at DTF Ink. Kevashan knows his way around DTF powders, film peels and the quirks of coastal print rooms.

Talk to DTF Ink

Tell us about your printer, film, powder and press settings and our team will help you get repeatable transfers. Meadowdale lab in Germiston, plus seven studios.