Cure Check Kit

Using Cure Check Kit

Add a quick peel and wash check before every run and stop guessing about your DTF curing.

Cure Check Kit

How the Cure Check Kit fits into your DTF workflow

Add the Cure Check Kit right after your usual DTF print, powder, and cure steps. Once you’ve printed and powdered as normal, cure a coupon or peel card alongside your transfers. Press as you would for your production job, then peel and check the result. Note any glossiness, tackiness, powder residue, or edge issues immediately. For a full check, use a wash test coupon pressed to a scrap garment or offcut, then launder it before approving a new batch or powder.

Use fresh cards or coupons for every shift or new operator, and especially after changing powder, film, or press settings.

Typical starting points to dial in your settings

Start with these baseline settings for most DTF applications:

- Cure powder: 2 to 3 minutes at 100 to 120 degrees C in an oven

- Or 3 to 5 minutes hovering under a heat press at 140 to 150 degrees C with a 4 to 7 mm gap

- Press transfer: cotton at 150 to 165 degrees C for 10 to 15 seconds, polyester at 125 to 140 degrees C for 10 to 15 seconds

- Peel: hot peel within a few seconds, cold peel after a minute or more

Always defer to your powder and film specifications, and log any changes on the kit checklist.

Common mistakes and how the kit helps you catch them

The most frequent curing errors are under-curing (tacky, dull, or powdery finish that washes off) and over-curing (yellowing, brittle or stiff results). Sometimes press temperature drifts or local humidity shifts, causing results to change across a shift. The Cure Check Kit flags a missed cure on the first batch it affects.

Another common issue is forgetting to check each new film or powder batch. Use the kit every time you change consumables, switch operators, or notice a change in press behaviour.

Customer reviews

What our DTF Ink customers say

Verified Google reviews

Talk to DTF Ink

Tell us about your printer, film, powder and press settings and our team will help you get repeatable transfers. Meadowdale lab in Germiston, plus seven studios.