Film PET 100
Using Film PET 100
Film PET 100 runs best with careful cold-peel workflow.

Step-by-step cold-peel DTF with Film PET 100
Start by loading the film matte-side up and running a nozzle check, especially on white. Print your DTF design in mirror, making sure your white underbase is dense and stable. After printing, dust the wet ink with DTF Ink Powder Soft Hand for best results on soft garments. Gently shake off excess powder without touching the print area.
Cure the powdered print in a DTF oven for 2 to 3 minutes at 110 to 120 degrees, or hover under an open press for 3 to 5 minutes at 140 to 150 degrees. The powder should look glossy and have a faint orange-peel texture when ready.
- Matte side up for printing
- Mirror all artwork
- Powder and shake off well
- Cure to glossy orange-peel
Starting settings for reliable results
Here are typical starting points to test with Film PET 100. For pressing onto cotton, go for 155 to 165 degrees, 12 to 15 seconds, medium-firm pressure. Polyester needs lower heat, try 130 to 140 degrees, 10 to 12 seconds. Always let the print cool fully (at least a minute) before peeling low and slow. For best durability, finish with a 10 second press using a Teflon sheet.
If in doubt, check the print room temperature and humidity. Low humidity dries the print quicker and may need slightly less oven time.
Avoid these common cold-peel mistakes
The most common slip is rushing the peel, Film PET 100 must be properly cool before you remove the film, or you’ll lift ink and lose detail. Sometimes users forget to shake off all the excess powder, which leaves a gritty feel. If the transfer edges look ragged, check your white ink agitation and run a nozzle check. Another easy-to-make error is pressing too hot or too long, which can scorch polyester or make the transfer go stiff.
Dont skip wash testing a sample before a big run. If you see poor wash durability, revisit your curing step and check powder coverage.
Related press workflows and recipes
Customer reviews
What our DTF Ink customers say
Verified Google reviews
Talk to DTF Ink
Tell us about your printer, film, powder and press settings and our team will help you get repeatable transfers. Meadowdale lab in Germiston, plus seven studios.

