Film PET 75
Using Film PET 75
Film PET 75 streamlines your print to press path with reliable hot peel release.

How to use Film PET 75 hot-peel in your DTF setup
Start by loading the 60 cm roll into your printer. Print your image in mirror, ensuring the white underbase prints last for crisp opacity. Once done, evenly powder the wet print with a fine DTF Ink TPU powder, shaking off all excess. Depending on your setup, cure the powder in an oven at 110 degrees C for about 2 to 3 minutes or by floating the transfer under a heat press at 145 degrees C for 4 minutes.
Once the powder is cured and cool to the touch, align the transfer on your pre-pressed garment. Press at 155 degrees C for approximately 12 seconds at medium-firm pressure. Peel the film away cleanly within five seconds, Film PET 75 is engineered for a true hot peel, saving you time between presses.
Test settings before every new batch
Every print room is different, so always start new rolls or batches with a small test. Typical starting points: print as usual, apply fine powder, cure at 110 to 120 degrees C for 2 to 3 minutes (oven) or float under the press at 145 to 150 degrees C for 3 to 5 minutes. On-press, use 150 to 165 degrees C for cotton, 10 to 15 seconds, hot peel within five seconds, and finish with a 5-second repress through a Teflon sheet for best durability.
- Note room humidity beside each test print
- Keep the test print with the roll label
- Retest after any oven or press change
Glue left behind, film curl and other PET 75 snags
If the film resists peeling or leaves glue behind, check your powder: make sure it is fully cured and not under-cooked or over-cooked. In humid conditions, powder may clump or the film may wrinkle; store film sealed and handle powder in small batches. If the print cracks or looks patchy, inspect your white ink for settling or nozzle problems, and confirm your press heat is accurate with an infrared thermometer.
Edge lifting? Repress for 5 seconds through Teflon. Tacky or dull finish? Go a few degrees higher on the cure or adjust your press dwell.
Related press workflows and recipes
Customer reviews
What our DTF Ink customers say
Verified Google reviews
Talk to DTF Ink
Tell us about your printer, film, powder and press settings and our team will help you get repeatable transfers. Meadowdale lab in Germiston, plus seven studios.

