Powder Soft Hand

Using Powder Soft Hand

Light, even coverage keeps fine DTF prints soft and sharp.

Powder Soft Hand

How to use Powder Soft Hand from print to press

After printing your DTF design onto PET transfer film, immediately powder the wet print with Powder Soft Hand. Use a gentle shake to cover every edge, then tip and tap the film to remove excess powder. Its fine texture is excellent for holding detail and preventing powder mounds along the print edges.

Cure the powdered film in an oven at about 110 to 120 degrees Celsius for 2 to 3 minutes, or hover under an open heat press with a 5 mm gap at 140 to 150 degrees for 3 to 5 minutes. The correct cure will give a glossy, slightly orange-peel look. Under-cured powder feels tacky, while over-cured powder may yellow or stiffen. Allow the film to cool before pressing onto the garment.

Typical starting settings for soft-hand jobs

Test these starting points for best results on cotton or blends:

Warm-up press: 2 to 5 seconds, so damp cotton dries out before the soft-hand transfer lands.

Press: 150 to 165 degrees Celsius for 10 to 15 seconds, medium-firm pressure.

Peel: Most films are hot peel, but always check your film type.

Finishing press: 5 to 10 seconds through Teflon or parchment.

  • Cure oven: 110 to 120°C for 2 to 3 minutes
  • Heat press hover: 140 to 150°C, 3 to 5 minutes, 5 mm gap
  • Press: 150 to 165°C for 10 to 15 seconds
  • Peel: Hot or cold, check the film used

Powdery edges, stiff patches and their fixes

If the transfer peels with a powdery edge or feels rough, check for excess powder left on the print, tap off more firmly next time. If prints are lifting or washing off, suspect under-curing: check that your oven or hover plate reaches the right temperature with an infrared thermometer. For yellowing or stiff patches, the powder has been over-cured or the press is too hot.

Keep opened powder bags sealed, and do not let the powder pick up moisture or dust. If you are unsure, press a small sample on scrap fabric and wash-test it before starting large runs.

Customer reviews

What our DTF Ink customers say

Verified Google reviews

Talk to DTF Ink

Tell us about your printer, film, powder and press settings and our team will help you get repeatable transfers. Meadowdale lab in Germiston, plus seven studios.