Powder Workwear
Using Powder Workwear
Workwear powder brings extra grip to every transfer.

Applying Powder Workwear in the DTF workflow
After printing your CMYK plus white underbase, coat the wet print with Powder Workwear by hand or with an automatic powder shaker. The hard-melt formula holds fine detail on heavy fabrics and resists early release during curing and pressing. Always wear gloves and a dust mask when powdering by hand. Shake off excess powder thoroughly, especially with detailed artwork, to avoid a rough transfer edge.
Typical cure and press settings for Workwear powder
Start with these settings and adjust for your bay:
• Cure in oven: 2 to 3 minutes at 100 to 120°C
• Hover heat press: 3 to 5 minutes at 140 to 150°C, 4 to 7 mm gap
• Press cotton: 150 to 165°C, 10 to 15 seconds, medium-firm pressure
• Press polyester: 125 to 140°C, 10 to 15 seconds, usually cold peel
Workwear powder typically suits both hot and cold peel films, but always check the transfer film data.
- 2 to 3 min oven at 100 to 120°C
- 3 to 5 min hover press at 140 to 150°C
- Cotton: 150 to 165°C, 10 to 15 sec, medium-firm
- Polyester: 125 to 140°C, 10 to 15 sec, cold peel
Common slip-ups with workwear powder
The most frequent issue is under-curing, which leaves transfers tacky and prone to washing off. Always check that cured powder looks glossy with a light orange-peel texture. Over-curing can yellow the transfer or make it stiff, especially on lighter fabrics. If you see powder shedding after pressing, double-check your oven or press for cold spots with an infrared thermometer. A test strip on each batch will help you lock in the right settings before running the full order.
Customer reviews
What our DTF Ink customers say
Verified Google reviews
Talk to DTF Ink
Tell us about your printer, film, powder and press settings and our team will help you get repeatable transfers. Meadowdale lab in Germiston, plus seven studios.

