Film Sheet A3

Using Film Sheet A3

Film Sheet A3 makes short-run DTF transfers simple and repeatable.

Film Sheet A3

How to use Film Sheet A3 in the DTF workflow

Start by removing one A3 sheet from the sealed pack, handling only by the edges or using lint-free gloves. Load it into your A3 DTF printer’s manual feed tray, matte print side up. Print your design using standard DTF inks, remember to agitate your white ink before starting the job. Once printed, apply DTF Ink TPU powder (Soft Hand or Workwear, depending on your garment) to the wet ink, shake off the excess, then cure the sheet in an oven or under a hovering press.

After curing, place the transfer film ink-side down on your pre-pressed garment. Press using the recommended settings for your fabric and the film type (hot or cold peel). Peel away the film as indicated, hot peel within a few seconds, or cold peel after cooling.

  • Handle sheets carefully to avoid fingerprints
  • Use a dust-free area for powdering
  • Test each batch before main production

Starting settings for print, cure and press

Film Sheet A3 follows typical DTF workflow settings, but always check your printer and powder recommendations. Use these as starting points, then adjust as needed:

Print: Standard A3 DTF settings, with daily white agitation.

Powder: Fine Soft Hand for smooth cotton, Workwear for poly blends.

Cure: 100 to 120 degrees C for 2 to 3 minutes (oven), or 140 to 150 degrees C hovering 4 to 7 mm for 3 to 5 minutes.

Press: Cotton 150 to 165 degrees C, 10 to 15 seconds, medium pressure. Polyester 125 to 140 degrees C, cold peel.

  • Always confirm with a test print
  • Check for glossy, orange-peel finish after cure

Smudged corners, weak white and other A3 sheet slips

Common issues with A3 sheet film include printing on the wrong side, using stale or un-agitated white ink, over-powdering (leading to blobby edges), and under-curing (leaves print tacky). Sheet film does not like damp or static-heavy rooms, watch for powder clumping or sheets sticking together.

If you see patchy white, always run a nozzle check and shake the white ink. For film curl or static, check your humidity (aim for 45 to 60 percent). If prints aren’t releasing, confirm you’re using the correct peel method for your film type. A quick test peel on a spare scrap saves expensive mistakes.

Customer reviews

What our DTF Ink customers say

Verified Google reviews

Talk to DTF Ink

Tell us about your printer, film, powder and press settings and our team will help you get repeatable transfers. Meadowdale lab in Germiston, plus seven studios.